[Gasification] Thomas Reads gasifier

[Jeff Davis]

Dear Japple,

You may like the below link:
http://www.clean-air.org/Ed%20Burton%20Story/wood_chips_to_bio.htm

Also check Doug's page below:
http://www.fluidynenz.250x.com/

I think a disc chipper is best not the wheel type that road crews use. Others 
could say for sure.

A sawmill and swingsaw would make the best wood fuel. Maybe 1.5" to 2" square 
(small blocks).


Jeff


On Saturday 20 January 2007 03:56 am, japple wrote:
> Thom I am building your tractor mounted gasifier I purchased from you some
> time back. Have built the gas. unit have yet to build the filter.Have used
> over center clamps to hold unit together as I can see alot of taking to
> bits, this is by the way. What I would like to know is the easy way to make
> wood into fuel chips?High H.P.rotary chipper?what size of chip?.Blocks of
> wood? what size? best method of poducing them. What ever fuel we make I
> feel low H.P. is a must. I am a semi retired practical engineer with a very
> good work shop, so come feed us some idears,if plans are available.    
> Regards   japple _______________________________________________
> Gasification mailing list
> Gasification at listserv.repp.org
> http://listserv.repp.org/mailman/listinfo/gasification_listserv.repp.org
> http://gasifiers.bioenergylists.org

-- 
Jeff Davis
Somewhere 20 miles south of Lake Erie, USA
http://www.velocity.net/~jeff0124