[Stoves] Motor speed controls

[Greg Manning]

Greetings Robert...

Try this:

http://store.qkits.com/moreinfo.cfm/K2636

Their kits are complete with parts, and well built...

Greg Manning



-----Original Message-----
From: stoves-bounces at listserv.repp.org
[mailto:stoves-bounces at listserv.repp.org]On Behalf Of Robert Deutsch
Sent: Sunday, December 03, 2006 11:17 AM
To: stoves at listserv.repp.org
Subject: [Stoves] Motor speed controls


Dear Electronicos

I beg everyones indulence to go slightly off subject while we're talking
about DC Motor speed controls.  I would like to ask assistance with a
problem.  I need to build a speed control to replace a burned out unit
(since lost) that my dad built years ago for a drill press used for drilling
and tapping threaded holes.  With the standard drill press pulley set-up he
used to be able to make the spindle crawl at about 4 rpm with good torke.

The motor is a MINACON dc motor rated at 1/3 hp, 90 VDC, 1800 RPM, 3.4 AMP.

If anybody has some ideas on where to find a speed control design that might
do the trick, please drop me line off the listserv.

Best regards,

Robert-


_______________________________________________
Stoves mailing list
Stoves at listserv.repp.org
http://listserv.repp.org/mailman/listinfo/stoves_listserv.repp.org
http://www.bioenergylists.org

--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.15.6/565 - Release Date: 12/2/2006

--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.15.6/565 - Release Date: 12/2/2006