[Stoves] Hensel Paint Can Gasifier Stove, pressure & flow

[AJH]

On Wed, 09 May 2007 22:22:41 +0100, Steve Taylor wrote:

>AJH wrote:
>> No, at least not yet, would you attempt a resend please?
>>   
>I did it from another system, 

It's possible it may be blocked if it was from an address the system
hasn't learned yet.


>I'll try again tomorrow.

Nothing yet!


> What I did was to 
>remove Jim's secondary air holes, and replace them with punched louvres 
>to generate a swirl. 

Revisiting this: when I was young people would modify car bonnets by
cutting slits and raising them to louvres, was a special tool used to
form them in one operation?

I can envisage such a device working on the same principle as a "mole"
self locking wrench, the jaws of the wrench engaging with the
tincanium and held at the right downward angle ( I use around 10
degrees)then slitting and forming the louvre as the handles are
squeezed, does that sound practical?

AJH